--> You can check my previous post to understand what is WCCP by clicking here (http://networkingmaterials.blogspot.com/2017/09/introduction-to-wccp.html).
--> WCCP can be configured on the Router, Multilayer Switch as well as Firewall.
--> In this post, I will explain how to configure WCCP on the Router.
Step1: Configure WCCP Version 2
Router(config)# ip wccp version 2
Step2: Specify the IP Address of WSA in an ACL.
Router(config) # access-list 10 permit host 192.168.2.200
Step3: Specify which traffic needs to be redirected to WSA using an ACL.
Router (config)# access-list 100 permit tcp any any eq 80
Router (config)# access-list 100 permit tcp any any eq 443
Router (config)# access-list 100 permit tcp any any eq 8080
Step4: Configure WCCP Service IP and combine all the parameters
Router (config)# ip wccp 50 group-list 10 redirect-list 100 password cisco
Step5: Apply WCCP on the interface of the Router.
Router (config)# int fa0/0.100
Router (config-if)# ip wccp 50 redirect in
Ref: Cisco.com
Md.Kareemoddin
CCIE # 54759
0 Comments