How to configure ASA Active/Standby Failover??

ASA1 Configuration

S1: Configure the interfaces as shown in the topology.

ASA1(config)# interface g0/1

ASA1(config-if)# nameif Inside

ASA1(config-if)# Security-level 100

ASA1(config-if)# ip address 192.168.1.1 255.255.255.0 standby 192.168.1.2

ASA1(config-if)#exit

ASA1(config)# interface g0/2

ASA1(config-if)# nameif Outside

ASA1(config-if)# Security-level 0

ASA1(config-if)# ip address 192.168.2.1 255.255.255.0 standby 192.168.2.2

ASA1(config-if)#exit



2) Configure Active/standby Failover on ASA1 and make ASA1 as Active ASA.

ASA1(config)# Failover lan unit primary

3) Make G0/0 on ASA1 as Failover Interface between ASA1 and ASA2.

ASA1(config)# failover lan interface Failover G0/0

Note: Failover is the name given to G0/0 interface, it is similar to Inside and Outside which is given to G0/1 and G0/2

4) Configure IP Address on Failover Interface Ip Address.

ASA1(config)# failover interface ip Failover 10.0.0.1 255.255.255.0 standby 10.0.0.2

5) Configure encryption for failover communication between ASA1 and ASA2

ASA1(config)# failover key Cisco123

6) Implement stateful failover on G0/0 of ASA1.

ASA1(config)# failover link Failover

7) Implement Failover

ASA1(config)# Failover


ASA2 Configuration

ASA2(config)# failover lan unit secondary

ASA2(config)# failover lan interface Failover G0/0

ASA2(config)# failover interface ip Failover 10.0.0.1 255.255.255.0 standby 10.0.0.2

ASA2(config)# failover key Cisco123

ASA2(config)# failover link Failover

ASA2config)# failover

Verification # show failover


0 Comments